;QTS AN-X2 MOD RIO Scan Configuration Utility
;Copyright (c) 2005-2016 Quest Technical Solutions
;Auto Config Ethernet/IP File Ver4.1.14

;ScanModProg
;RedundEna,MOD_A_  ; Enable Redundant configuration and specify Redund Prefix
;LongInp           ; Force drops to send all inputs on every scan
LedModeDebug       ; Not ODVA Compliant, but useful for debugging network

ClxName,AnxModMas
ClxPrefix,MOD_


ClxSlot,0

DataOutput ; ,<ClxBaseTag> Outputs from ControlLogix
;  0,RedundCtl  ; Len=1 Redundancy Control
  1,d4s5,d04s5_Out,; Len= 2 DDO_353_00 DC OUT 24V 4x8
  3,d4s7,d04s7_Out,; Len= 4 ACO_020_00 AN OUT 4CH CURR
  7,d5s3,d05s3_Out,; Len= 4 B872 ANALG 4 CH O  B872
 11,d5s4,d05s4_Out,; Len= 1 B804 16-OUT B804

DataInput ; ,<ClxBaseTag> Inputs to ControlLogix
  0,DropErr  ; *** Always Map to Ofs 0 Since Logix will set to all 1's if AN-X Connection is lost
  2,d4s4,d04s4_Inp,; Len= 2 DDI_353_00 DC IN 24V 4x8 Sink
  4,d4s6,d04s6_Inp,; Len= 9 ACI_030_00 AN IN 8CH UNIPOLAR
 13,d5s2,d05s2_Inp,; Len= 4 B863 REG 4 CH IN B863


;The following lines map Diagnostics into ClxSlot 15

ClxSlot,15

DataOutput
  0,DiagCtl   ; Len=1 Set Bit 0 to clear diagnostic counters

DataInput  ; ,<ClxBaseTag> Inputs to ControlLogix
  0,DiagCtrs, ; Len=10  S908 Diagnostic Counters
 10,ScanSts   ; Len=5   S908 Scan Status
 15,d4ModHlth,; Len=5
 20,d5ModHlth,; Len=5

;Module Status Byte for Quantum Only
 25,d4ModSts,  4 ;

;ControlLogix Connection Statistics
 30,ConnStats0, ; Len=10
 40,ConnStats15, ; Len=10